Eicon Networks S52 Manual de servicio descargar pdf (Pagina 26)

Software Configuration

page 26

CHAPTER 4

Software Configuration

Configuration with installed hardware

After you have installed your Dialogic

Diva

Media Board and the board drivers as described in Software

Installation on page 17, you can start the Dialogic

Diva

Configuration Manager:

1. Click Start > Programs > Dialogic Diva > Configuration Manager.

2. The Diva Configuration Manager displays the configuration you chose during the software installation:

• The detected Dialogic

Diva

Media Board is installed.

• The Diva board is assumed to be connected to a corresponding ISDN BRI, PRI, or analog line.

• Line properties are either set by default or to the parameters you set in the Dialogic

Diva

Installation

Wizard.

Notes:

• If you plan to use Channelized T1 Robbed Bit Signaling, then change the switch type in the line

properties to "T1 Robbed Bit Signaling (RBS)" and your PRI line will change automatically into a T1

line (see "Line Properties" in the Diva Configuration Manager Online Help file (DSMain.chm)).

• If you plan to use "Direct Access Mode" or "R2 Signaling E1", then change the switch type in the line

properties accordingly and your PRI line will change automatically into an E1 line (see "Line Properties"

in the Dialogic

Diva

Configuration Manager Online Help file (DSMain.chm)).

• If you installed a fully detected Diva board and chose Default installation during the driver update, then

RAS and Dialogic

Diva

API/CAPI are installed and connected to the Diva board.

• If you installed a fully detected Diva board and chose Customized installation or Secure installation

during the driver update, then the services you selected are installed and connected to the Diva board.

RAS and Diva API/CAPI are configured to accept all incoming calls. This can cause conflicts between the two

services, since both services are then listening to the same phone numbers. To avoid these conflicts, you

should assign different MSNs, phone numbers, or extensions to the services in the binding properties for

each service (see "Binding Properties" in the Diva Configuration Manager Online Help file (DSMain.chm)).

When you are using a North-American D-channel protocol with a Dialogic

Diva

BRI Media Board, you must

always assign ISDN numbers because otherwise incoming calls cannot be accepted (see "Binding Properties"

in the Diva Configuration Manager Online Help file (DSMain.chm)).

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 57 58

Comentarios a estos manuales

Sin comentarios

Eicon Networks S52 Manual de servicio Pagina 26

Comentarios a estos manuales

Relacionado con productos y manuales para Módems Eicon Networks S52