Eicon Networks 1530 Guía de usuario descargar pdf (Pagina 123)

Command Line Interface 123

SET V25BIS RIDTR RidtrDelay

Defines the amount of time between receipt of ring signal detection and the issuance of Data

Terminal Ready (DTR) on. If this delay is exceeded, the call is abandoned. This delay must not

exceed the value for SET V25BIS RING.

Range: 0-30000 milliseconds. Default: 1000.

SET V25BIS HANGUP HangupDelay

Defines the amount of time after the line is disconnected before a new command can be issued.

This is used to give the modem enough time to prepare to accept other commands.

Range: 0-65 seconds.

Default: 2.

SET V25BIS DSRLOSS DSRlossDelay

Defines how long Data Set Ready (DSR) must be lost to determine that there has been a valid

loss of carrier, not just a temporary fluctuation. A valid loss of DSR usually means the modem

will hang up.

Range: 0-10000 milliseconds.

Default: 1500.

SET V25BIS RING RingDelay

Defines the permitted delay between rings. If this timer is exceeded, it is assumed that the caller

has hung up.

Range: 1-9000 milliseconds.

Default: 5000.

SET V25BIS TRANSITION TransitionDelay

Defines the maximum delay for Data Set Ready (DSR) to be set to OFF after Data Terminal

Ready (DTR) is set to OFF. Normally DTR is set to OFF upon a disconnection request.

Range: 0-65 seconds.

Default: 2.

SET V25BIS OFFHOOK OffHookDelay

Defines the delay before going into data transfer mode.

Range: 0-4000 milliseconds.

Default: 2000.

SET V25BIS CTSON ProgMessDelay

Defines the delay between sending a command message to the V.25bis modem and its

acceptance. If this timer is exceeded then the command message is returned with an error code.

Range: 200-4000 milliseconds.

Default: 200.

SHOW V25BIS CONFIGURATION

Displays the configuration settings for the V.25BIS dialer.

1 2 ... 118 119 120 121 122 123 124 125 126 127 128 ... 161 162

Sin comentarios

Eicon Networks 1530 Guía de usuario Pagina 123