Eicon Networks S52 Guía de usuario Pagina 57

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 91
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 56
Eicon Connections for Linux User’s Guide
page 55
CHAPTER 7
Modem and Null-Modem Cables
This section describes the modem and null-modem cables available from Dialogic and how to
use them. It also includes diagrams showing the pin-out wiring and signals for each cable, as
well as instructions for making null-modem connections between two systems.
Connecting Two Workstations
This section describes how to connect two Linux servers, each with an Eiconcard, back-to-back
using a null-modem cable. Depending on the types of Eiconcards you are linking, cable
requirements vary. Match the correct cable to the Eiconcards you want to link.
Which Cables to Use?
The table below shows which null-modem cables to use to connect specific kinds of interfaces.
For further information on cable diagrams and part numbers, see the respective sections on
Modem and Null-Modem Cables in this section. Remember that not all cables are symmetrical:
both ends of a cable are not necessarily identical.
Eiconcard Interface Target Eiconcard Cable
C-Class V.24 (RS-232-C) C-Class V.24 Null-Modem Cable
S-Class V.24 or V.35 S-Class V.24/V.35 HSI/HSI Null-Modem
Cable
S-Class X.21 S-Class X.21 HSI Null-Modem Cable
C-Class V.24 S-Class V.24 HSI Modem Cable, with the
HSI Null-Modem Conversion Cable
Vista de pagina 56
1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 90 91

Comentarios a estos manuales

Sin comentarios