Eicon Networks ISDN NT1 Guía de instalación descargar pdf (Pagina 24)

ENGLISH

Installation24

(B) Connect your Diva Server adapter

How you connect your adapter depends on the type of Diva Server adapter you

have:

• To connect a Diva Server BRI adapter, follow the instructions below.

• To connect a Diva Server PRI adapter, follow the instructions on page 26.

• To connect a Diva Server Analog adapter, follow the instructions on page 30.

Connect your Diva Server BRI adapter

Note: If you plan to use your Diva Server BRI adapter as network termination for

back-to-back operation or connection to PBX networks, go to page 25.

In Europe and most countries worldwide:

In Europe as well as most countries except North America and Japan, connect

your ISDN line using the cable included with your Diva Server adapter.

In North America, Japan and some other countries:

In North America, Japan and a few other countries, you need an NT1 to connect

your ISDN line. You can order an NT1 from Eicon Networks or from another

supplier. Make sure that a power supply is available for the NT1 of this line.

Usually, a PBX is installed in the same area as the NT1 and the service provider

can use the power supply of the PBX for the ISDN line as well. If this is not the

case, you have to order a combo device from your service provider. This device

consists of an installation rack into which an NT1 module and a power supply

module is mounted.

1. Take the cable included with the

adapter and plug one end into the

adapter.

ISDN wall jack with NT

2. Plug the other end into the ISDN

wall jack.

Diva Server

BRI adapter

VoIPon www.voipon.co.uk [email protected] Tel: +44 (0)1245 808195 Fax: +44 (0)1245 600030

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 127 128

Sin comentarios

Eicon Networks ISDN NT1 Guía de instalación Pagina 24