Eicon Networks CX1 Manual de instalación descargar pdf (Pagina 64)

G&R

User applications using one of our communications APIs from the GlAPI

library must send the $*$CN, $*$DIS and $*$BRK messages themselves

when using the Gline API, but they will be sent automatically by CMALLC,

CMDEAL and CMSERR when one of our CPI-C APIs is used. The PAD

service messages can only be used from the Gline API.

The connect command

$*$CN remoteaddress,userdata

The only information required is the X.25 number to be called in numeric

format, and the user data if needed in hexadecimal. Remote address is given as

a numeric X25 subscription. User data is three hexadecimal bytes.

Note that you can set the default values for the connect commands with para-

meters in the configuration file, but that if no default is configured then the last

value used for this particular field becomes the default. So if you make an error

in one of the parameters you need not specify the others in your next connect.

If you set all connect parameters in the configuration file you can connect from

most of the Host Links products using a single key connect command, or by

transmitting $*$CN.

The disconnect and break commands

All systems accept:

$*$DIS

force disconnection (normally done by application).

$*$BRK

interrupt application, against turn if necessary.

Gline Line Handlers and Configuration

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 132 133

Sin comentarios

Eicon Networks CX1 Manual de instalación Pagina 64