Eicon Networks C31 Especificaciones Pagina 1

www.eicon.comEiconcard C3x Familyfor Type II PCMCIA Bus

10 The V.24 DCE InterfaceThe V.24 DCE InterfaceA pin-out diagram for the V.24 DCE interface is shown in Figure 3. The signal definitions and names are

Technical Specifications 11Technical SpecificationsTechnical Data• Type II PCMCIA Release 2.1 compliantHardware Installation• Automatic configuration

12 International Regulatory InformationInternational Regulatory InformationRegulatory Information for the USA:WARNING. Changes or modifications to thi

Regulatory Information for the USA: 13FCC Part 68 NoticeThis unit complies with Part 68 of the FCC rules. On the bottom of this equipment is a label t

14 Regulatory Information for CanadaRegulatory Information for CanadaNOTICE: The Industry Canada label identifies certified equipment. This certificat

Regulatory Information for Europe 15Regulatory Information for Europe EU Declaration of ConformityEN: Eicon Networks Corporation declares that this eq

203-049-02

www.eicon.comSecond Edition (January 2002) 203-049-02Eicon, Eiconcard, and the Eicon logo are either trademarks or registered trademarks of Eicon Netw

www.eicon.comTable of ContentsIntroduction ... 5Installing the Eiconcard C3x...

www.eicon.com

Introduction 5IntroductionThe Eiconcard C3x is a Type II PCMCIA Release 2.1-compliant card that offers X.25 through a V.24 serial port at speeds of up

6 Installing the Eiconcard C3xInstalling the Eiconcard C3xTo install the Eiconcard C3x in your PC, you must insert it into the PC’s PCMCIA slot, and t

Installing the Eiconcard C3x 74 Connect to the outside worldYou are now ready to connect the Eiconcard C3x to the outside world. • To set an ISDN co

8 Making an ISDN ConnectionMaking an ISDN ConnectionNote Only the Eiconcard C31 supports ISDN connections.After you have installed your Eiconcard C31,

Making a VHSI Connection 9Making a VHSI ConnectionThe Eiconcard C3x can connect as a DTE to devices such as Data Service Units (DSUs) which supports V