Eicon Networks P92 Guía de instalación descargar pdf (Pagina 8)

8 EiconCard P92 Installation Guide

Connection Status Indicators

The green LED adjacent to each port on the EiconCard P92—see

Figure 1 on page 6—provides a convenient indication of the status of

the connection on that port. The LED indicates the status as follows:

Table 2. Explanation of LED States

LED State Connection Status Remedy

Off The port is not loaded (the configuration

file describing protocol and interface

parameters has not been read by the

device driver on the PC).

Consult your networking

software for instructions on

how to load a configuration file

and how to start a connection.

Rapid Flash

(stays on for

1/2 second)

The connection has not been established.

Either the port is loading OR there is no

response from the destination device

OR the EiconCard P92 is waiting for a

VHSI cable to be connected to the port.

Verify that the cable is

properly connected to the port.

If the light continues flashing

after a few minutes, verify that

the destination device is active.

Slow Flash

(stays on for

1 second)

The connection was interrupted

unexpectedly. The cable was unplugged

or damaged while a connection was

active.

Reconnect the cable.

On The port is active and the connection

is good.

203086-1.FM5 Page 8 Friday, February 28, 1997 10:35 AM

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 31 32

Sin comentarios

Eicon Networks P92 Guía de instalación Pagina 8