Eicon Networks DIVA T/A ISDN Modem Guía de usuario descargar pdf (Pagina 12)

DIVA T/A ISDN Modem User’s Guide

◆

Page 12

Windows 95/98/NT Installation and Setup

Windows 95 (OSR2)

This install procedure is for Windows 95 Service Release 2 (OSR2). If you are using original

release or Service Pack 1 (SP1) version of Windows 95, go to “Windows 95 (Original Release

and SP1)” on page 10.

To verify the version installed on your machine, click ‘Start’, ‘Settings’, ‘Control Panel’, ‘System’,

then click the ‘General’ tab. If you have Windows 95 OSR2 installed, you should see

‘4.00.950 B’, as shown.

DUN 1.2 or Later Required

If you are using Dial-Up Networking (DUN), make sure you are using version 1.2 or later. If you

are running a previous version, you must upgrade to DUN 1.2 or later before installing the

DIVA T/A. For your convenience, DUN 1.3 is included on the DIVA T/A CD-ROM; run SETUP.EXE

from the CD-ROM and click ‘Bonus Software’.

Setup Instructions

Follow these steps to set up the DIVA T/A under Windows 95 (OSR2).

Power on your PC with all cables connected (see page 7

for instructions).

Windows 95 detects the DIV AT/A and the ‘New Hardware Found’ window appears

followed by the ‘Update Device Driver Wizard’ window.

Insert the DIV AT/A CD into your computer's CD drive.

From the ‘Update Device Driver Wizard’ window, click ‘Next’.

Click ‘Other Location’.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 145 146

Sin comentarios

Eicon Networks DIVA T/A ISDN Modem Guía de usuario Pagina 12