Eicon Networks DIVA T/A ISDN Modem Guía de usuario Pagina 172
- Pagina / 191
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Appendix C: Command Line Reference ISDN Access Time
172
ENABLE ISDN DELAY56K {DEFAULT | VALUE delay}
Valid context: General
An attempt is made to automatically re-establish a data call at 56 kbps if a data call attempt failed at 64 kbps
due to network congestion, or if a service or option was not available or not configured.
DEFAULT: Immediately try to connect at 56 kbps if a call fails at 64 kbps. In Australia and Japan, do not retry.
VALUE delay: Specifies how long to wait before retrying. Range 0 to 10 seconds., 254 (use pre-configured
values depending on region), 255 (no retry).
DISABLE ISDN DELAY56K
Valid context: General
SHOW ISDN STATISTICS
Valid context: General
Displays statistics for the two ISDN channels.
SHOW ISDN STATUS
Valid context: General
Displays ISDN status information.
SHOW ISDN CONFIGURATION
Valid context: General
Displays ISDN configuration information.
ISDN Access Time
ADD ISDN ACCESSTIME days time {IN | OUT | ANY| BLOCKED}
Valid context: General
Defines the times during which ISDN data calls can be made or received.
For example, the command \"add isdn accesstime mon-fri 9:00-17:00 IN\" enables incoming calls Monday to
Friday, from 9AM to 5PM.
days: Starting and ending days, separated by a hyphen. Range: mon, tues, wed, thur, fri, sat, sun. Range must
be within the same week (sun-sat). You can specify only one day as well.
time: Starting and ending time in hours and minutes, separated by a hyphen.
Time must be within the same day (0:00 - 24:00).
IN: Allow incoming calls only.
OUT: Allow outgoing calls only.
ANY: Allow both incoming and outgoing calls.
BLOCKED: Prohibits both incoming and outgoing calls.
SET ISDN ACCESSTIME index {DAYS | TIME | DIRECTION} item
Valid context: General
Changes the settings for an entry in the ISDN ACCESSTIME table. These entries define the times during
which ISDN calls can be made or received.
index: Entry number in the table.
DAYS: Change the setting for starting and ending days. Separate days by a hyphen. Range: mon, tues, wed,
thur, fri, sat, sun. Range must be within the same week (sun-sat). You can specify only one day as well.
- DIVA LAN ISDN Modem 1
- User’s Guide 1
- Table of Contents 3
- Chapter Three: 4
- Chapter Four: 4
- Chapter Five: 4
- Chapter Six: 5
- Chapter Seven: 5
- Chapter Eight: 6
- Chapter Nine: 6
- Chapter Ten: 6
- Appendix A: 7
- Appendix B: 7
- Appendix C: 7
- Appendix D: 8
- Introduction 9
- Internet 10
- Connecting more computers 12
- Total network security 12
- Summary of features 13
- Contacting customer services 14
- Getting Started 15
- 1. Installation overview 16
- 2. Prepare for installation 17
- Important ISDN concepts 19
- ISDN channel usage 19
- Multilink PPP 20
- Multilink PPP + BACP 20
- Multilink PPP + AO/DI 20
- Gather ISDN information 22
- Gather X.25 information 23
- Gather V.120 information 23
- Power Supply 24
- FaxPhone 24
- ISDN Wall Outlet 24
- To install Modem Monitor 26
- What’s next? 34
- Starting Modem Monitor 36
- Properties dialog box 37
- Utilities dialog box 38
- Options dialog box 38
- Status Viewer 39
- Profile table 40
- Utilities 40
- Chapter Four 41
- Saving configuration settings 43
- Getting help 43
- General settings 43
- Connection profile settings 43
- Editing the ISP profile 44
- Editing LAN settings 45
- Viewing status information 46
- Obtaining statistics 47
- Eicon\DIVA LAN ISDN Modem\ELM 48
- Resetting to factory defaults 49
- Minimizing ISDN Charges 50
- The Cost Control page 51
- Data call thresholds 52
- ISDN billing intervals 52
- Configuring BACP 53
- Configuring AO/DI 54
- X.25 on the D-channel 56
- Click Save 57
- Click Reset 57
- Setting ISDN active intervals 58
- Spoofing NetBIOS services 59
- Data compression 60
- Manual dialing 61
- Restricting analog calls 62
- Data over voice 63
- Traffic filtering 64
- Security 65
- Security features 66
- System password 67
- Automatic log out 67
- Network address translation 68
- Remote management 70
- Incoming data calls 72
- Call authentication 74
- Custom security features 78
- Setting up the Phone Ports 79
- Assigning phone numbers 80
- Call bumping 84
- Supplementary services 86
- Call Hold 87
- Call Waiting 87
- Notes on call bumping 89
- Call Forwarding 90
- Three-party Conference Call 91
- Terminal Portability 92
- Chapter Eight 93
- Overview 94
- 1. Gather information 95
- Minimizing your ISDN charges 100
- Configuring security features 101
- Advanced Installations 102
- Connection retries 103
- Using Modem Monitor 104
- Manual installation 105
- 106 106
- To create a VPN 108
- Connecting to the VPN 109
- Defining routes 110
- IP routes 111
- 117 117
- 118 118
- IP filters 119
- Default filters 120
- To define a filter 120
- Action Direction 121
- Source /Destination 121
- Location 121
- ProtocolAddress 121
- 122 122
- IP filtering examples 123
- 124 124
- Blocking web surfing 125
- 126 126
- Making a V.120 connection 127
- 128 128
- SecurID support 129
- 130 130
- Other Configuration Tools 131
- Configuration options 132
- Web interface 133
- TFTP interface 133
- 134 134
- DTMF interface 135
- Command line interface (CLI) 136
- 137 137
- About configuration context 138
- Connection profiles 138
- Default profiles 138
- Command line reference 138
- Loading firmware with the CLI 138
- 139 139
- TCP/IP Configuration 140
- Installing TCP/IP 141
- Configuring TCP/IP 141
- 142 142
- 143 143
- 144 144
- Configuring TCP/IP on an iMac 145
- Technical Information 146
- 147 147
- E1, E2, E3, E4 148
- 149 149
- 150 150
- Termination 151
- Command Line Reference 152
- Notational Conventions 153
- Commands 154
- Callback 155
- Call screening 156
- Call thresholds 157
- 158 158
- 159 159
- Ethernet 160
- 161 161
- 162 162
- 164 164
- 165 165
- 166 166
- IP routing 167
- IP various 167
- 168 168
- 169 169
- 170 170
- 171 171
- ISDN Access Time 172
- Logging and Mail Trace 173
- 174 174
- SHOW MLPPP CONFIGURATION 175
- 176 176
- 177 177
- 178 178
- 179 179
- 180 180
- Profiles 181
- 182 182
- 183 183
- 184 184
- Time Protocol 185
- 186 186
- V.120 Scripting 187
- 188 188
- 189 189
- Regulatory Information 190
- Safety Status: TNV-1 191
- Power Consumption 191
Relacionado con productos y manuales para Redes Eicon Networks DIVA T/A ISDN Modem
Redes Eicon Networks Eicon 1550 Especificaciones
(8 paginas)
(8 paginas)
Redes Eicon Networks 800-241 Guía de usuario
(52 paginas)
(52 paginas)
Redes Eicon Networks 1530 Guía de usuario
(162 paginas)
(162 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.053 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales