Eicon Networks ISDN NT1 Guía de instalación descargar pdf (Pagina 16)

Making a VHSI connection

page 16

Making a VHSI connection

(S series Eiconcards only)

The VHSI port can be used to connect the Eiconcard as a DTE to

devices such as Data Service Units (DSUs) that support one of the

following interfaces: V.24, V.35, EIA-530, V.36/RS-449, or X.21.

It can also be used to connect the Eiconcard directly to a host

computer, or back-to-back with a VHSI port on another Eiconcard.

If multiple VHSI ports are present on an Eiconcard, each port is

configured independently.

To use a particular interface, simply install the appropriate cable.

The Eiconcard recognizes the cable and automatically prepares the

port for that interface.

Consult the documentation which came with your networking

software for more information about port configuration.

VHSI cables

The following table lists the most common connections supported

by the VHSI port, and specifies the part number of the required

Dialogic cable. For information on making your own cables, see

“VHSI port specifications” on page 21.

Interface Connection Part #

V.24 to V.24 DCE 300-077

to V.24 DTE 300-078

V.35 to V.35 DCE 300-076

to V.35 DCE (France) 300-083

EIA-530 to EIA-530 DCE 300-080

V.36/RS-449 to V.36/RS-449 DCE 300-079

X.21 to X.21 DCE 300-081

Direct to VHSI port on another Eiconcard 300-075

64-0308-09.fm Page 16 Monday, March 15, 2010 3:32 PM

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 51 52

Sin comentarios

Eicon Networks ISDN NT1 Guía de instalación Pagina 16