
Across the Boards
Communications Device Drivers
Section 6 - MAINCON Driver Configuration
Page 274
cfSOFTWARE Confidential,
2000
6.20 MAINCON Panel D7
DEC VT320
Configuration filename: MAINCFG.320
Used by cf Device Drivers:
#
Name Description
102 CFX320X VT320 Driver
113 CFX320X3 WOW VT320 Async
__________________
ACROSS-THE-BOARDS(r) Config
__________________
Page 1 of 14
---- Protocol Converter (DEC VT320) ----
Autowrap (0 or 1)....................... 0
Reset needed after BELL? (0=No, 1=Yes).. 0
XON/XOFF (in hex) FF if no XON/XOFF..... 11 13
Hardware flow control (0/1/2)........... 0
Flicker check time (in 100ths second)... 0
Keystroke delay (in milliseconds)....... 0
COMM port (1 - 15)...................... 1
Line Speed/Parity/Data bits/Stop bits... 1200 E 7 1
Half duplex (0 or 1).................... 0
Transmit rate limiting (0/1)............ 0
0: Data does not wrap to next line when the margin is reached. 1: Data wraps to
the next line when margin is reached.
F10: write config to disk Esc: Exit PgDn: next config menu
1. Autowrap
When set to ‘1’, this switch causes the cursor to wrap to the beginning of the next line automatically when
the last position in a line is written to by the protocol converter.
2. BEL Reset
If the protocol converter locks the keyboard after sending a BELL character, setting this switch to ‘1’ will
cause a RESET key sequence to be sent after receiving a BELL. The RESET key is defined in the 3101
KEY TABLE.
3. XON
If the protocol converter uses XON/XOFF pacing, specify the XON character used in this field. Use 0FFh
for no XON/XOFF processing. 11h is the standard XON.
4. XOFF
If the protocol converter uses XON/XOFF pacing, specify the XOFF character used in this field. Use 0FFh
for no XON/XOFF processing. 13h is the standard XOFF.
Comentarios a estos manuales