Eicon Networks CX1 Especificaciones descargar pdf (Pagina 77)

Across the Boards



Communications Device Drivers

Section 6 - MAINCON Driver Configuration

Page 227

cfSOFTWARE Confidential,



2000

6.4 MAINCON Panel B2

CUT Mode/Single Session

DCA Irma Coax Card

Configuration filename: MAINCFG.IRM

Used by cf Device Drivers:

Name Description

1 CFXIRMA Irma/Irma2/Irma3

81 CFXIRMA3 WOW Irma/Irma2/Irma3

__________________

ACROSS-THE-BOARDS(r) Config

__________________

--------------- DCA Irma ---------------

Irma Card Model......................... 0

First I/O port address (in hex)......... 220

CUT mode model and EAB support.......... 2

0=Original IRMA card, 2=Irma2, 3=Irma3.

F10: write config to disk Esc: Exit

1. Irma Model

The type of Irma card installed. ‘0’ = any Irma card or compatible. ‘2’ = Irma 2. ‘3’ = Irma 3. If ‘0’, only

I/O port origin 220h and model 2 (or 2E) is supported. If ‘2’ or ‘3’, models 3, 4 and 5 (and 3E and 4E) are

supported. If ‘3’, model 5E is also supported (model 5E is not supported on the Irma 2).

2. I/O Port Origin

If the I/O port base address on the Irma card has been changed from the normal 220h, this field must be

configured. If the I/O port origin is not 220h, model 5 (or 5E) is not supported.

3. CUT Model/EAB

The 3270 model to use. ‘2’ = 24x80, ‘3’ = 32x80, ‘4’ = 43x80, ‘5’ = 27x132. If followed by an ‘E’ (e.g.,

‘2E’, ‘3E’, ‘4E’ or ‘5E’), then Extended Attribute Bytes (EABs) will be supported.

See the restrictions

under #1 and #2 above

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 231 232

Sin comentarios

Eicon Networks CX1 Especificaciones Pagina 77