Eicon Networks CX1 Especificaciones descargar pdf (Pagina 55)

Across the Boards



Communications Device Drivers

Section 5 - General Configuration and Usage Information

Page 205

cfSOFTWARE Confidential,



2000

5.16 LU6.2 Configuration (continued)

VTAM

VTAM 3.4 or later is recommended. Note: the following discussion assumes that the emulator connects directly

to a VTAM rather than through an NCP. The NCP configuration requirements are similar to the VTAM

configuration described below, but are not otherwise discussed.

The VTAM supporting (e.g., connected to) the PC should be set up as an APPN node. The following VTAM

startup parameters may need to be specified:

NODETYPE=NN

NETID=USCFSW00

REVIEW

CPCP=YES

Review the relevant IBM documentation prior to changing these values.

NOTE

: The NETID of USCFSW00 is used for illustration only in this documentation, your

installation’s actual SNA NETID should be substituted.

A major node should be defined for the emulator’s private PU.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 231 232

Sin comentarios

Eicon Networks CX1 Especificaciones Pagina 55