Eicon Networks CX1 Especificaciones descargar pdf (Pagina 87)

Across the Boards



Communications Device Drivers

Section 6 - MAINCON Driver Configuration

Page 237

cfSOFTWARE Confidential,



2000

6.11 MAINCON Panel C2, cfDFT Coax (continued)

6. Trace Size in KB

Defines the size of the allocated trace buffer in KB. If zero, the cfDFT trace is disabled. Specifying an odd

trace size will perform a “before and after” trace, an even trace size will trace before or after as is

appropriate for the event being traced. In general, the cfDFT trace should only be enabled when instructed

to do so by cfSOFTWARE. cfSOFTWARE will also specify the type of trace required.

7. cf INT

cfDFT requires a software interrupt for communications to the loaded cfDFT TSR. The default of 60h is

acceptable unless it conflicts with other software in the PC. 60h through 6Fh are valid entries.

8. SNA, Non-SNA

‘S’ if the attached 3174 controller is SNA, ‘N’ if the controller is non-SNA.

9. Session # Model/EAB

The 3270 model to use. ‘2’ = 24x80, ‘3’ = 32x80, ‘4’ = 43x80, ‘5’ = 27x132. If followed by an ‘E’ (e.g.,

‘2E’, ‘3E’, ‘4E’ or ‘5E’), then Extended Attribute Bytes (EABs) will be supported. Each host session may

have a different model configured.

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 231 232

Sin comentarios

Eicon Networks CX1 Especificaciones Pagina 87