Eicon Networks S93 Guía de instalación descargar pdf (Pagina 16)

Basic drivers 16

Installing the network protocols

Depending on the purpose of the ISDN connection, different network protocols are

required. Install the network protocols that you want to support (NetBEUI, TCP/IP, or IPX).

Before installing Diva Server for Windows NT, check that the required protocols are

installed on the system:

1. Select ‘Start > Settings > Control Panel’. Double-click ‘Network’.

2. Select the ‘Protocol’ tab.

• If the required protocols are shown in the list of network protocols, they are already

installed on the system. Click ‘Close’.

• If one or more required protocols are not shown in the list, they will have to be

added. Click ‘Add’. Select the required protocol and click ‘OK’. Follow the on-screen

instructions and then close the network configuration. Restart the computer when

prompted.

Installing the basic drivers

You should not attempt to install your Eicon Diva Server adapter at the same time as the

Windows NT operating system.

Installation of the adapter drivers under Windows NT 4.0 is described below. If you want

to install the Diva Server for Windows NT software in unattended mode, refer to the chapter

Installation in Unattended Mode

on page 86.

Note: You must be logged on as ‘administrator’ to install Diva Server for Windows NT.

1. Click ‘Start > Run’.

2. Type the path to the installation file:

• Insert your Diva Server CD-ROM and enter the following path:

D:\DRIVER\WINNT\ENGLISH\SETUP.BAT

(where D: is your CD-ROM drive letter).

• Or enter the path to the installation file on the hard disk, e.g.:

C:\ISDN\SETUP.BAT

(where C: is your hard disk letter).

Click ‘OK’.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 129 130

Sin comentarios

Eicon Networks S93 Guía de instalación Pagina 16