Eicon Networks S93 Guía de instalación descargar pdf (Pagina 46)

Eicon Port driver 46

Generic Server Modem

To configure the Generic Server Modem, check the ‘Advanced Parameters’ check box

and select ‘Generic Server Modem’.

Support calls with synchronous PPP

Check the option ‘Support calls with synchronous PPP’ if the virtual COM Port driver

should accept incoming calls with synchronous PPP (ISDN-specific framing method used

by ISDN networking products). By default, the virtual COM Port driver can only be used

for incoming calls from asynchronous devices.

Accept analog calls

Check the option ‘Accept analog calls’ if the server should accept calls from analog remote

devices. This option should be enabled in most cases.

Allow Callback

The Generic Server Modem is designed for incoming calls only. Nevertheless, callback is

possible. If you want the virtual COM Port driver to support RAS callback, enable the

option ‘Allow Callback’. In the RAS callback scenario, the remote user is automatically

disconnected after authentication and then called back. The virtual COM Port driver

registers the properties of the incoming call and applies the same properties to the

outgoing callback.

Callback Timeout [s]

The option ‘Callback Timeout [s]’ sets the period in seconds after which the incoming call

properties are deleted from the virtual COM Port driver if no callback has been established.

The callback cannot be established after the callback timeout has expired.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 129 130

Sin comentarios

Eicon Networks S93 Guía de instalación Pagina 46