
Installation in Unattended Mode 88
• Common components section (see Common components section on page 101): The
components that are common for all Diva Server adapters are the WAN Miniport, the
Eicon Port driver and the CAPI interface driver. You can configure the WAN Miniport
and the Eicon Port driver. The section names for the WAN Miniport and the Port driver
are ‘WAN’ and ‘MODEMS’.
General section
The general section defines which optional components will be installed. The default
values are shown below:
[GENERAL]
WAN=YES
MODEMS=YES
CAPI=YES
Use the general section only, if you want to install the optional components with their
standard values and do not define a common component section for them. If you want to
define common component sections for the optional components, change the settings
shown above to ‘NO’ or delete the general section.
If you are installing multiple adapters, change these settings to ‘NO’ as well (see also
Installing multiple adapters
on page 112).
Diva Server adapter section
This section describes the parameters for the basic ISDN driver. The name of the section
depends on the type of adapter that is installed. See the following table for the correct
section names:
Adapter Section name
Diva Server BRI-2M DSBRI
Diva Server BRI-2M 2.0 DSBRI_2
Diva Server 2FX DS2FX
Diva Server Voice BRI-2M 2.0 DSBRI_2_VOICE
Diva Server 4BRI-8M DS4BRI
Diva Server Voice 4BRI-8M DS4BRI_VOICE
Diva Server 4BRI-8M 2.0 DS4BRI_2
Diva Server Voice 4BRI-8M 2.0 DS4BRI_2_VOICE
Diva Server PRI versions (PRI, PRI-9M, PRI-23M,
PRI-30M)
DSPRI
Comentarios a estos manuales