Eicon Networks S93 Guía de instalación descargar pdf (Pagina 67)

Using Dial-Up Networking or RAS Administration 67

8. Enter the phone number of the server required in the ‘Phone Number’ dialog box.

If the server is configured to use subaddresses, you must specify the appropriate

subaddresses in the ‘Phone Number’ dialog box, separated by the vertical stroke ‘|’,

(the pipe symbol or [Alt] and the digits [0], [1], [2] and [4] on the numeric keypad).

For example, if the phone number is 07152932940 SUB 41, you must enter

07152932940|41.

If your connection protocol is something other than synchronous HDLC, you must

specify which protocol is used. This information can be attached to the server phone

number, separated by a ‘^’.

For example, for an analog call, add ‘^MODEM’ to the phone number of the server.

For a call to GSM, add ‘^GSM1’, ‘^GSM2’, or ‘^GSM3’.

If your connection uses something other than a transfer rate of 64 kbps, you must

specify which rate is used. This information is also attached to the server phone

number, separated by a ‘^’.

For example, for a call to a region in the United States where a line, a switch, or a

device only supports a transfer rate of 56 kbps, add ‘^56K’ to the phone number of

the server. The ‘RBS T1’ switch type always uses a transfer rate of 56 kbps. Therefore,

you must add ‘^56K’ for all outgoing calls if you use this switch type.

The required information can be found in the following table. The various parameters

can also be entered in combination.

Designation Description

Framing

^HDLC synchronous HDLC

^X.75 synchronous X.75

^ASYNC additional information asynchronous

^SYNC additional information synchronous

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 129 130

Sin comentarios

Eicon Networks S93 Guía de instalación Pagina 67