Eicon Networks S93 Guía de instalación descargar pdf (Pagina 56)

CAPI 2.0 56

CAPI 2.0

Diva Server for Windows NT provides the CAPI 2.0 interface for CAPI-based applications.

If CAPI 2.0 has already been installed, see Installing and configuring CAPI 2.0, step 4 (on

page 57).

About CAPI installation and configuration

• The CAPI 2.0 driver makes the supported Diva Server adapters available for CAPI 2.0

applications.

• Applications that use CAPI 2.0 can use the CAPI 2.0 drivers to access various

controllers, numbered from 1 to n. Every controller provides a basic-rate access or a

primary-rate access to the ISDN or access to channelized T1.

• When installing the CAPI driver, the number of controllers is defined by the number of

ISDN adapters installed on the system. This standard assignment may be accepted if

all ISDN adapters are to be used with the CAPI interface.

• Normally, each adapter is assigned to one controller. The Diva Server 4BRI or Voice

4BRI adapters appear to the system as four separate adapters and therefore have four

CAPI controllers.

Installing and configuring CAPI 2.0

1. Click ‘Start > Run’.

2. Type the path to the installation file:

• Insert your Diva Server CD-ROM and enter the following path:

D:\DRIVER\WINNT\ENGLISH\SOFTWARE\SETUP.BAT

(where D: is your CD-ROM drive letter).

• Or enter the path to the installation file on the hard disk, e.g.:

C:\ISDN\SOFTWARE\SETUP.BAT

(where C: is your hard disk letter).

Click ‘OK’.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 129 130

Sin comentarios

Eicon Networks S93 Guía de instalación Pagina 56