Eicon Networks S93 Guía de instalación descargar pdf (Pagina 38)

Remote Access Service (RAS) 38

When installing Diva Server for Windows NT for the first time, the new ports must be added

first.

1. Click ‘Add’.

2. Select ‘ISDN1-DIWAN’, and click ‘OK’.

3. Repeat this procedure for each additional B-channel to be set up as a port in the RAS

Setup.

The ‘Remove’ function may be used to delete a port. The ‘Clone’ function sets up the next

new port with the same parameters as the selected port.

Port configuration

Select a port to configure and click ‘Configure’. The ‘Configure Port Usage’ dialog box

appears:

The following settings may be configured for every port:

• Dial out only: Client configuration. Only outgoing ISDN connections can be

established.

• Receive calls only: Server configuration. Only incoming calls are accepted.

• Dial out and Receive calls: If the port is to be used both as a client and a server port.

Outgoing connections can be established and incoming calls can be received.

In the server version of Windows NT, ‘Receive calls only’ is preset. In the workstation

version, ‘Dial out only’ is preset.

Note: In the workstation version of Windows NT, only one port can be configured to

receive calls. This enables a peer-to-peer connection of two workstations. This does not

limit the number of simultaneous outgoing calls. Operation as a server for multiple clients

remains limited to the server version of Windows NT.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 129 130

Sin comentarios

Eicon Networks S93 Guía de instalación Pagina 38