Eicon Networks S93 Guía de instalación descargar pdf (Pagina 21)

Basic drivers 21

3. If you have selected ‘One SPID’ or ‘Two SPIDs’, enter the SPID numbers specified by

your ISDN service provider in ‘SPID’.

Hardware Settings

If you are using a Diva Server BRI-2M ISA-bus adapter and you need to configure specific

hardware resources, select ‘Hardware Settings’ from the ‘Page’ box.

Disable ‘Automatic Configuration’ and enter the required I/O port base address and

interrupt number.

For a list of supported base addresses and interrupt numbers, see the printed installation

guide that came with your adapter.

Advanced Parameters

Configuration of additional parameters is required only in a few special cases. Mark the

‘Advanced Parameters’ field for this. The options ‘Advanced Settings, ‘ISDN Protocol

Settings’, and ‘ISDN Line Settings’ appear under ‘Page’. See Advanced Settings

below,

ISDN Protocol Settings

on page 22, and ISDN Line Settings on page 23.

Advanced Settings

The ‘Advanced Settings’ tab contains parameters for configuring your Diva Server adapter

for specific application environments.

Note: With a Diva Server 4BRI or Voice 4BRI adapter, the ‘Advanced Settings’ must be

specified individually for each of the four controllers (controller [1] to controller [4]). Select

‘[<controller number>] Advanced Settings’ for each of them.

• Specify how voice data are transmitted over the ISDN line.

• Specify if your Diva Server adapter is used as terminal equipment or network

termination.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 129 130

Sin comentarios

Eicon Networks S93 Guía de instalación Pagina 21